Prepare.
Confirm your surface and read the instructions supplied for your specific logo. Clean and dry the area; check the intended placement before removing the backing.
INSTALLATION & CARE
Install your logo.
Care for the finish.
Many standard floor and platform logos are suitable for self-installation. Confirm the surface and follow the instructions supplied with your specific product.
FROM ARTWORK TO YOUR FLOOR
Self-installation,
with written guidance.
Many standard floor and platform logos can be self-installed. Start with the right surface and the directions for your product.
Position.
Measure the clear area and center your mascot. Keep the placement clear of seams, rack feet and any features identified during application review.
Apply.
Follow the supplied sequence for backing removal, pressure, rolling and any required heat. The method depends on the approved product and surface.
Care.
Use the recommended neutral cleaner. Avoid soaking, power scrubbers and dragging equipment. Do not bend or roll branded rubber platforms without guidance.
Care for the graphic and its edges.
Clean gently.
Use a damp cloth and neutral cleaning solution. Avoid harsh chemicals, powered scrubbers and pressure washing.
Keep water from standing.
Do not soak the graphic or let water collect around its edges.
Protect against concentrated contact.
Do not drag equipment over graphics. Report spikes, cleats, skate blades and direct weight impacts before ordering.
Keep branded rubber flat.
Do not bend, roll or relocate a branded rubber platform without the proper instructions.
Follow the installation and care instructions supplied with your order.
Unsure about your surface?
Send the details before you order.
Start a project briefINSTALLATION SUPPORT
Bring in a professional installer.
Prefer professional installation? We can refer you to our network of qualified installers and help you understand the expected scope and pricing. Installation is quoted separately.
Request installer guidance